Plasterboard finishing technology

[zihadhosenjm40]

The best brands of plasterboard
The leading manufacturers of gypsum boards in Russia are:

Lafarge.
Rigips.
Giproc.
The quality of all these brands of rich people data is not bad. But the most popular in our country are still the sheets of "Knauf". This company supplies three main types of plasterboard to the domestic market:

wall thickness 12.5 mm;
ceiling - 9.5 mm;
arched - 6.5 mm.
If desired, today you can purchase both standard sheets of this manufacturer 2500 x 1200 mm, and non-standard ones. The width of the latter can be 600-1500 mm, the length - 1500-4000 mm, and the thickness - 6.5-24 mm.

There is no need to do any special preparation of the walls when using gypsum plasterboard. In this case, the surfaces are usually simply cleaned of dirt and dust. Then, a special aluminum or steel profile is mounted on the wall using a level. The plasterboard itself is attached to it using specially designed dowels with wide plastic heads. The gypsum plasterboard sheets are fixed during installation so that no cross-shaped seams are formed between them.

At the final stage, the plasterboard surface can either be covered with wallpaper or treated with a thin layer of plaster. Of course, finishing putty is often used for finishing plasterboard.

Lining, plywood and plastic panels
Such materials are also usually used when surfaces deviate greatly from the horizontal or vertical. In addition, such finishing can also be used when the walls need not only to be leveled, but also insulated.