Video installation instructions

[zihadhosenjm40]

Such casings can be fixed with liquid nails or other glue. The presence of a cable channel also allows you to hide the wiring inside the structure. A significant disadvantage of such casings is the difficulty in dismantling them.


Plastic door trims for plastic doors are available in a wide range of colors, which allows you to choose a decorative element of the desired color, in accordance with the customer's requirements. When purchasing a set of trims, it would be a good idea to check it for surface defects, which are almost impossible to eliminate, especially on colored strips.

Fastening the casing
Before installing the trims, you need to take the necessary measurements first. It will be almost impossible to fix an incorrectly made joint between the trims. The installation of the trim is described in detail in the video.

The technology for installing plastic casing is not much different from the generally accepted one. The only significant difference is that there is no need to cut the base very precisely. Any processing defects will be hidden by a decorative overlay.


The photo above shows how to properly trim ecuador mobile database vertical and horizontal sections of the casing. As a rule, first the vertical posts are cut at an angle of 45 degrees, and then, after fitting and marking, the horizontal crossbar. After cutting, the base can be attached to the wall. Depending on the wall material, fastening can be done in any way, even with regular or liquid nails. In the case of using materials such as brick, concrete, etc., it is necessary to first drill holes in the wall with a drill with a carbide tip, and fasten with plastic dowels (photo below).


Please note that if there are any uneven parts of the wall, there must be a fastener in the deepest part of the depressions, otherwise a gap between the frame and the wall cannot be avoided. The decorative trim must be cut with special care. When cutting, use a miter box - a special device for accurately maintaining an angle of 45 or 90 degrees. (see photo).