The design options for roller gates will appeal to many car owners
Posted: Thu Feb 06, 2025 9:48 am
The cost of a medium-sized sectional overhead door (height 2 m, width 3 m) will be about 60–70 thousand rubles.
Sectional doors require constant maintenance, as they consist of numerous parts, elements and mechanisms that are constantly in operation.
Low resistance to burglary. It is advisable to install this type of gate only in a protected area.
This type of gate has such a name due to the ivory coast mobile database it is placed when opening and closing. They consist of several basic elements:
Individual profile strips (lamellas) connected into a single piece.
The mechanism that sets the closing surface in motion.
Two guide profiles holding the canvas.
A special lever that unlocks the structure in the event of a power outage.
The shaft on which the fabric is wound.
The entire structure has a flexible surface, which allows it to fit into a small box. Its installation can be done in several ways:
with indoor placement;
outside;
overhead installation inside the garage;
overhead - outward.
Roller and roller shutter structures are made of aluminum and steel. Both categories of gates are equipped with a special system with a mechanical lift in case of an emergency.
For steel structures, the maximum gate dimensions are: width - up to 7 meters, area no more than 49 m2. The canvas is assembled from galvanized steel profiles up to 0.8 mm thick. A box for twisting the canvas is installed if its area is no more than 11 m2.
For aluminum structures, the maximum permissible dimensions are: width up to 6 meters with an area of ​​up to 14 m2. Such gates are made of aluminum profile: extruded or filled with special foam.
Sectional doors require constant maintenance, as they consist of numerous parts, elements and mechanisms that are constantly in operation.
Low resistance to burglary. It is advisable to install this type of gate only in a protected area.
This type of gate has such a name due to the ivory coast mobile database it is placed when opening and closing. They consist of several basic elements:
Individual profile strips (lamellas) connected into a single piece.
The mechanism that sets the closing surface in motion.
Two guide profiles holding the canvas.
A special lever that unlocks the structure in the event of a power outage.
The shaft on which the fabric is wound.
The entire structure has a flexible surface, which allows it to fit into a small box. Its installation can be done in several ways:
with indoor placement;
outside;
overhead installation inside the garage;
overhead - outward.
Roller and roller shutter structures are made of aluminum and steel. Both categories of gates are equipped with a special system with a mechanical lift in case of an emergency.
For steel structures, the maximum gate dimensions are: width - up to 7 meters, area no more than 49 m2. The canvas is assembled from galvanized steel profiles up to 0.8 mm thick. A box for twisting the canvas is installed if its area is no more than 11 m2.
For aluminum structures, the maximum permissible dimensions are: width up to 6 meters with an area of ​​up to 14 m2. Such gates are made of aluminum profile: extruded or filled with special foam.