Even if you plan to steam and wash in different rooms,
Posted: Mon Feb 10, 2025 6:23 am
you still need to install a drain in the steam room. After each bath procedure, you need to thoroughly rinse this section from a hygienic point of view.
Drain hole with grate
Since gravity sewerage is most often used in the bathhouse, when laying pipes it is necessary to maintain a slope of 2-3 cm per linear meter. Floors should also be made with a slope towards the drain hole.
If the gravity sewerage system will drain wastewater from different rooms, then it is necessary to install a ventilation riser.
Where water enters the drain hole and flows into the sewer pipe, there should be a water seal that prevents unpleasant odors from entering the bathhouse.
SEWAGE SYSTEM. EXTERNAL NETWORKS AND STRUCTURES SNiP 2.04.03-85
SNiP 2.04.03-85
In addition, when designing external sewerage, it is macedonia mobile database to take into account 2 natural parameters:
type of soil;
depth of soil freezing.
The last factor is also important to know when laying internal drainage pipes. This point for some subjects of Russia is indicated in the table.
More detailed information taking into account the type of soil, as well as calculations are given in SNiP 2.02.01-83 and SNiP 23-01-99. If it is not possible to lay communications deeper than this mark, then the pipes must be insulated.
Let's take a closer look at the process of laying a system for removing and disposing of waste water from a bathhouse.
Concrete screed and drain
The type of sewerage system inside the bathhouse depends on the type of floor. Currently, concrete screed is most often used. Tiles can be laid on it or a slatted wooden floor can be installed on joists. The gap between the floorboards in the latter case will be about 5 mm.
Drain hole with grate
Since gravity sewerage is most often used in the bathhouse, when laying pipes it is necessary to maintain a slope of 2-3 cm per linear meter. Floors should also be made with a slope towards the drain hole.
If the gravity sewerage system will drain wastewater from different rooms, then it is necessary to install a ventilation riser.
Where water enters the drain hole and flows into the sewer pipe, there should be a water seal that prevents unpleasant odors from entering the bathhouse.
SEWAGE SYSTEM. EXTERNAL NETWORKS AND STRUCTURES SNiP 2.04.03-85
SNiP 2.04.03-85
In addition, when designing external sewerage, it is macedonia mobile database to take into account 2 natural parameters:
type of soil;
depth of soil freezing.
The last factor is also important to know when laying internal drainage pipes. This point for some subjects of Russia is indicated in the table.
More detailed information taking into account the type of soil, as well as calculations are given in SNiP 2.02.01-83 and SNiP 23-01-99. If it is not possible to lay communications deeper than this mark, then the pipes must be insulated.
Let's take a closer look at the process of laying a system for removing and disposing of waste water from a bathhouse.
Concrete screed and drain
The type of sewerage system inside the bathhouse depends on the type of floor. Currently, concrete screed is most often used. Tiles can be laid on it or a slatted wooden floor can be installed on joists. The gap between the floorboards in the latter case will be about 5 mm.